Browsing by author 1684

Jump to: 0-9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

or enter first few letters:  

Showing results 141 to 153 of 153. < previous 
Issue DateTitleAuthor(s)TypeAccess
2004The effect of holding pressure on the shrinkage and birefringence of injection moulded polypropylene platesPontes, A. J.; Oliveira, M.; Pouzada, A. S.Conference paperOpen access
2008The effect of thermal conductivity of RIM moulds in kinetics cureMateus, A.; Bártolo, Paulo Jorge; Mitchell, G., et al.Conference paperRestricted access (UMinho)
2008The effect of thermomechanical environment on the shrinkage and warpage in thermoplastic partsAlves, P. S.; Pontes, A. J.Conference paperRestricted access (UMinho)
2013The quest for a sustainable product : an environmental study of tyre recyclatesSimões, Carla L.; Simões, Ricardo; Carvalho, J. M. Valério de, et al.ArticleRestricted access (UMinho)
2007The use of stereolithography in direct toolingGuimarães, D. A.; Alves, A.; Pontes, A. J.ArticleRestricted access (UMinho)
2010Thermoelectrical regulation of microinjection mouldsQueirós, M. P.; Pontes, A. J.Conference paperOpen access
2014Tracking surgical instruments: from a management perspective to safety issuesSampaio, Álvaro M.; Simões, Ricardo; Pontes, A. J.Conference paperOpen access
2013Uni- and biaxial impact behavior of double-gated nanoclay-reinforced polypropylene injection moldingsPettarin, Valeria; Viau, Gastón; Fasce, L., et al.ArticleOpen access
2013Uni- and biaxial impact behaviour of double-gated nanoclay-reinforced polypropylene injection mouldingsPettarin, Valeria; Viau, Gastón; Fasce, L., et al.PreprintRestricted access (UMinho)
2012Using multi-objective evolutionary algorithms for optimization of the cooling system in polymer injection moldingFernandes, Célio Bruno Pinto; Pontes, A. J.; Viana, J. C., et al.ArticleOpen access
2009Using multi-objective evolutionary algorithms in the optimization of polymer injection moldingFernandes, Célio Bruno Pinto; Pontes, A. J.; Viana, J. C., et al.Conference paperOpen access
2010Using multiobjective evolutionary algorithms in the optimization of operating conditions of polymer injection moldingFernandes, Célio Bruno Pinto; Pontes, A. J.; Viana, J. C., et al.ArticleRestricted access (UMinho)
2014Yield, impact and fracture performance of injected metallic looking polypropylene partsCostantino, A.; Frontini, P.; Pettarin, V., et al.Conference paperOpen access